- USES & DESCRIPTION:
These single component heat resistant coatings based on silicone resin with heat resisting pigments are intended for use on surfaces exposed to high temperatures (1200-600℃) and exterior weathering. These coatings are lead and chromate free. Main applications are:
Hearth products, wood burning stoves, fire place inserts, space heaters
Exhaust systems(i.e.: stove exhaust pipes)
Barbecue grills
Lighting fixtures
Mufflers
- FEATURES:
- Excellent heat resistance (up to 1300℃).
- Excellent weathering resistance.
- Specific products developed for various substrates(iron,steel, cast iron, aluminum, cast aluminum)
- Excellent corrosion and surface hardness.
- TECHNICALDATA:
|
Color(s)
|
Black，White, Red, Blue
|
|
Mixing ratio
|
One pack
|
|
Volume solids
|
40%
|
|
Temperature resistance
|
1200℃
|
|
1300℃(Maximum moment temperature)
|
|
Specific gravity
|
1.1-1.5
|
|
Impact resistance
|
50 kg cm
|
|
Gloss （600）
|
0-25
|
|
Film thickness
|
Dry : 15~30μm /coat
|
Wet : 38~75μm /coat
|
|
Theoretical coverage
|
0.08kg / m2/20μm
|
|
Practical coverage
|
Various depending on application conditions, the geometrical complexity of the steel structure, weather condition, etc.
|
- STORAGE & HANDLING:
- Shelf temperature -5℃~40℃
- Flash point Greater than 28℃
This product must be stored in accordance with local, state, and national regulations. Preferred storage conditions: Keep containers in a dry space with adequate ventilation. The containers should be tightly sealed. Handle with care. Stir well before use.
- APPLICATION DETAILS:
Application methods:
|
Airless spray
|
Recommended
|
|
Nozzle tip
|
18~21 thou. inch
|
|
Fluid pressure
|
88~150kg/sq.cm
|
|
Thinning Ratio
|
0~5% by volume
|
Application temperature: -5℃~40℃
Drying schedule: 200℃ Drying Time 30mins
- SUBSTARTE PRE-TREATMENT:
- The key factor to prevent the failure is adhesion.
- Proper substrate pretreatment is critical to the performance of high service temperature products. Pretreatment may vary with substrate type and application.
- All oil and grease, as well as scale, must be removed. A 5-stage Iron Phosphate is recommended for optimum performance. For some applications a grit blast may be adequate.
- Remove rust, mill-scale and damaged primer by blasting to ISO Sa2.5 (SSPC-SP10) or by power tooling to ISO St3.0.
- Be sure that the surface is clean and dry prior to application.
- SAFETY PRECAUTIONS:
- Avoid skin and eye contact.If paint comes into contact with the skin and the eyes, flush with copious amount of water and seek immediate medical attention.
- Ensure good ventilation.Please keep them away from sparks and open flames.
- Observe all health and safety data on the contai
|
.gif)
.gif)
